Your position: Home > Stepper Drive
- Description
BD-3H Stepper Drive from Beijing KND CNC Technique Co. Ltd.
Production lead time: 15 days
If need wire transfer or any question please contact paycnc@paycnc.com
Production lead time: 15 days
If need wire transfer or any question please contact paycnc@paycnc.com
Power Supply |
AC220V -15% +10% 50/60HZ 5.5 A(MAX) | |||||||
Motor Phase Current |
1.0A to 6.8A | |||||||
Applicable Motor Type |
Three-Phase Hybrid Stepper Motor | |||||||
Operating Conditions |
Ambient temperature: 0℃ to 50℃ Ambient humidity: 15 to 85%RH . (No condensation) Free of corrosive or explosive gases Free of exposure to water, oil or chemicals Free of dust, salts or iron dust |
|||||||
Storage Conditions |
Ambient temperature:-25℃ to 70℃ Ambient humidity: 15 to 85%RH . (No condensation) |
|||||||
Control Method | Full-wave rectification PWM Sine-wave driven |
|||||||
Drive resolution |
0.03° | 0.036° | 0.045° | 0.06° | 0.072° | 0.09° | 0.12° | 0.18° |
Steps / rev | 12000 | 10000 | 8000 | 6000 | 5000 | 4000 | 3000 | 2000 |
Step Setting | Stepper 1 by Switch 1(SW1-6,7,8) Stepper 2 by Switch 2(SW2-6,7,8) |
|||||||
Input Signals | CP+/CP-;DIR+/DIR- | |||||||
Input Level | 5V, 5 to 10mA, Use 1K Ω cascade resistor when input level is 12 V, Use 2.2K Ω cascade resistor when input level is 24 V, The input circuit takes effect when input current is not zero |
|||||||
Pulse Input Mode |
Single-Pulse Mode: CP(Pulse)+ DIR(Direction) Pulse Width≥2.5µS; Pulse Frequency ≤ 200KHZ(10000 steps/rev) |
|||||||
Output Signals | RDY1/RDY2(Ready): Normally Open Contact; Put through when there is no fault; Max. load: 30V, 0.5A |
|||||||
LED Status Indicators |
Green LED RDY: Normal, Without Faults Red LED ALM1: Overcurrent ; ALM2: Overtemperature ALM3: Overvoltage ; ALM4: Undervoltage |
|||||||
Dimensions | 213×112×145mm | |||||||
Weight | 3Kg |