USD
AC Servo Drive Alarm
Q: We are using a CNC lathe with GSK 980TA control system, the X axis driver has No.4 alarm, after check it could not be mechanical problem, it occurs one or two times a day, sometimes it happened even running the MPG.
A: It could be the driver problem itself, you can change the drivers between the X and Z axis, if the same driver alarm for the Z axis, that means the alarm driver need to be repaired or replaced.
A: It could be the driver problem itself, you can change the drivers between the X and Z axis, if the same driver alarm for the Z axis, that means the alarm driver need to be repaired or replaced.
