USD
CNC lathe machine zero return error
CNC lathe machine zero return error
CNC Control system of the CNC lathe machine:
GSK980TD/DA98A, double speed spindle motor, 4 station tool post
(Other CNC controller like GSK980TDa,GSK980TDb, and AC servo driver DA98B, DA98D, same solution)
How to solve the problem:
Step 2-Is the machine zero return block on the CNC lathe looses?
Step 3-Check the contactor of the zero return switch, is it in poor contact?
Step 4-Check the encoder cable of the AC servo motor has problem or not?
Step 5-Is the AC servo motor has problems?
Step 5-Check the clutch or the timing belt slips or not? From www.CNCmakers.com
After check above steps, finally we found there is water inside the overtravel-limited switch, and the CNC lathe machine resume to work after we changed limited switch.
Conclusion: There was water come into the limited switch of X axis, which caused the poor contact, so there were zero return errors of X axis.
CNC Control system of the CNC lathe machine:
GSK980TD/DA98A, double speed spindle motor, 4 station tool post
(Other CNC controller like GSK980TDa,GSK980TDb, and AC servo driver DA98B, DA98D, same solution)
How to solve the problem:
- Problem detail: Errors happened by every zero return, a few millimeters and only on X axis, while Z axis and other functions are normal.
- Check if the problem is same as described by user: Try different zero-return methods and there are always errors on X axis.
- Diagnose: Normally if there are errors when zero-return we could check below steps:
Step 2-Is the machine zero return block on the CNC lathe looses?
Step 3-Check the contactor of the zero return switch, is it in poor contact?
Step 4-Check the encoder cable of the AC servo motor has problem or not?
Step 5-Is the AC servo motor has problems?
Step 5-Check the clutch or the timing belt slips or not? From www.CNCmakers.com
After check above steps, finally we found there is water inside the overtravel-limited switch, and the CNC lathe machine resume to work after we changed limited switch.
Conclusion: There was water come into the limited switch of X axis, which caused the poor contact, so there were zero return errors of X axis.
