GSK983Ma-H-4R Absolute Z position display
GSK983MA-H-4R User:
I have a parameter question, how do I make it so the Absolute Z position display is not affected by G43 tool length offset.
For example,
Tool #1 offset = 6.000”
Program:
G43Z4.H1
Then Absolute Position display says Z10.000 not Z4.000
I looked though parameters in manual and could not find the one to change.
CNCmakers Support:
Yes, there is no parameter setting for this, the software is designed to display the value of coordinate + length offset, it cannot be set by parameters.