USD
HOLD signal to activate Motor Brake
GSK218MC-H CNC Controller User:
1. Can I use the "HOLD" signal on the z axis driver to activate the motor brake? Or can I use the output through the I / O for the brake?
1. Can I use the "HOLD" signal on the z axis driver to activate the motor brake? Or can I use the output through the I / O for the brake?
2. How would I suggest using the power contactor for the axis drivers? Can I use the same "HOLD" signal to activate it? Or is it better to use an I / O output for this purpose?
CNCmakers Support:
1.
Use the "HOLD" signal on the z axis driver to activate the motor brake
1.
Use the "HOLD" signal on the z axis driver to activate the motor brake
2.Use the same "HOLD" signal to activate it.
What do you mean the power contactor, the driver can be input 220V/3phase directly.
What do you mean the power contactor, the driver can be input 220V/3phase directly.
