USD
How to install a electric turret?
Video on Youtube
The two locating pins must be positioned in an alternating (one forward, one reverse) orientation.
Screw the four rods into a diagonal configuration, ensuring the distance from the bottom of the rods to the surface of the movable ring is maintained between 7 and 8 mm.
Install the needle roller bearing first, then place the intermediate flat component (fitted with a locking nut); this component must be tapped firmly into place, as failure to do so will affect the accuracy of the rotation count.
Loosen the top cap to begin the disassembly/assembly of the tool holder.
Verify the orientation of the locating pins (alternating/opposing directions).
Adjust the four rods to a diagonal configuration.
Measure the height of the four rods (distance to the movable ring surface: 7–8 mm).
Install the upper slide block, aligning it with the four mounting holes.
Insert and install the side screws (No. 4 screws).
Install the needle roller bearing.
Install the locking nut and tap it firmly into place.
Paycnc offers different kinds of electric turrets
If you could not find the exact model, you can send item photo and its nameplate to paycnc@paycnc.com or WhatsApp us to get quotation.
The two locating pins must be positioned in an alternating (one forward, one reverse) orientation.
Screw the four rods into a diagonal configuration, ensuring the distance from the bottom of the rods to the surface of the movable ring is maintained between 7 and 8 mm.
Install the needle roller bearing first, then place the intermediate flat component (fitted with a locking nut); this component must be tapped firmly into place, as failure to do so will affect the accuracy of the rotation count.
Loosen the top cap to begin the disassembly/assembly of the tool holder.
Verify the orientation of the locating pins (alternating/opposing directions).
Adjust the four rods to a diagonal configuration.
Measure the height of the four rods (distance to the movable ring surface: 7–8 mm).
Install the upper slide block, aligning it with the four mounting holes.
Insert and install the side screws (No. 4 screws).
Install the needle roller bearing.
Install the locking nut and tap it firmly into place.
Paycnc offers different kinds of electric turrets
If you could not find the exact model, you can send item photo and its nameplate to paycnc@paycnc.com or WhatsApp us to get quotation.
